Cloud-electronics CDR-1B Manual de usuario descargar pdf (Pagina 4)

CDR‑1 & CDR‑1F Installation Guide v2.04

The CDR-1 & CDR-1F are remote control units specically designed for use with the

DCM-1/e. They may be tted to standard electrical back boxes in whatever location is

convenient in each zone.

Model types

The CDR-1 and CDR-1F are electrically and operationally identical, but differ in their

physical dimensions and mounting arrangements.

• The CDR-1 is a surface-mounting unit, which may be mounted via its supplied

mounting plate either to a single-gang back box, or directly to a suitable wall.

Max. projection from the wall is 30 mm.

• The CDR-1F is a ush-tting panel which ts to a standard dual-gang back box.

Max. projection from the wall is 10 mm.

Note: Where the term “CDR” is used in this manual, the text can be taken to apply to

both the CDR-1 and CDR-1F. In the section describing mounting (where the two types

differ), the full product names are used. An exception to this refers to the DCM-1/e’s

remote control ports, which are described as CDR-1 PORTS, to match the labeling

on the DCM-1/e itself.

A zone may have one CDR, more than one, or none at all. The DCM-1/e can support

up to 100 CDRs. CDRs are interconnected with standard CAT-5 UTP cable; units may

be daisy-chained at will and/or connected individually back to the DCM-1/e’s four

CDR-1 PORTS using almost any wiring topology convenient for the installation.

The CDR provides the user with the following local control functions for the zone in

which it is installed:

• Source selection

• Level control

• Group enable/disable (providing the zone has been dened as a group member)

• Local zone EQ adjustment (requires enabling on the DCM-1/e and entry of a key

code)

An Installer Mode permits zone assignment and adjustment of other installation

parameters.

Introduction

1 2 3 4 5 6 7 8 9 ... 19 20

Sin comentarios

Cloud-electronics CDR-1B Manual de usuario Pagina 4