Cloud-electronics CDR-1B Manual de usuario descargar pdf (Pagina 11)

CDR‑1 & CDR‑1F Installation Guide v2.0 11

4. Plug the cables into the CDR-1 sockets. The CAT-5 cable going to the mixer

(possibly via other CDRs) should be connected to the POWER IN socket. If other

CDRs are being installed further along the chain, the outgoing cable should be

connected to the POWER OUT socket. Ensure the RJ45 connectors fully latch

into place. If an external PSU is being used, plug it into the co-axial EXT POWER

socket.

J2 J1

MID

END

ON

OFF

POWER

OUT

POWER

IN

FROM

DCM-1

EXT POWER

RJ45 SOCKETS FOR

DATA

INTERCONNECTION

CO-AXIAL SOCKET

FOR EXTERNAL PSU

TO NEXT

CDR-1

5. Check that jumper J1 is in the OFF position. J2 should be set according to the

CDR-1’s position in the CAT-5 “chain”. If it is the nal (or only) panel in the chain

(i.e., nothing is plugged into the POWER OUT connector), set J2 to END; in all

other cases set it to MID. Carefully use tweezers or a pair of ne-nosed pliers for

this operation.

J2 J1

MID

END

ON

OFF

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comentarios a estos manuales

Sin comentarios