Cloud-electronics CXL-50T Manual de usuario descargar pdf (Pagina 3)

CXL-50T Installation Guide v1.0 3

4. Fitthetransformerwiththexingscrewthroughitscentralcore.Thetopof

the transformer has a threaded M6 insert; tighten the screw from underneath using

a hex key.

FRONT PANEL

MEDIA

PLAYER PCB

FRONT PANEL

CONTROLS PCB

MAINS

TRANSFORMER

CXL-50T OUTPUT

TRANSFORMER

MAIN PCB

CN15A

CN15B

100/70/50 V-LINE OUTPUT

CONNECTOR PCB

Red/Brown/

Blue/Black

White/Black

5. The primary winding of the transformer is terminated in a two-pin Molex-type

connector.ThisshouldbepluggedintotheheadermarkedCN15Bonthemain

PCB.Seediagramonpage4forlocation.

6. On the rear panel, remove the plastic blanking plate covering the LINE

OUTPUTconnectorhole.

7. Fit the 4-pin connector on the ends of the secondary winding leads from the

transformer (the remaining four) into this hole, so that the threaded holes in the

twoPCBmountingbracketslineupwiththetwoholesalongsidetheconnector.

Usethemaleendsofthehexpillars(supplied)tosecurethePCBandconnectorin

place.

8. Use the two cable ties supplied to tidy up the transformer leads; ensure that

they do not pass over the top of the main heat sink.

9. Replace the top cover, using the original screws.

10. Connect the speaker system to the line outputs using the mating connector.

Note that only two of the pins will be used; one will always be pin 1 (0 V).

1 2 3 4

Sin comentarios

Cloud-electronics CXL-50T Manual de usuario Pagina 3