Cloud-electronics LE-1MB Manual de usuario descargar pdf (Pagina 3)

LE-1 Series Installation Guide v2.0 3

PIN USE CAT-5 CORE

1 Left (cold) White + Orange

2 Left (hot) Orange

3 Sense White + Green

4 DC +ve Blue

5 0v White + Blue

6 DC -ve Green

7 Right (hot) White + Brown

8 Right (cold) Brown

SCN Screen Connector Shell

Wiring

The LE-1’s OUTPUT connector should be connected to one of the DCM1’s EXTENSION PORTs (Line inputs 1 to 4) with screened

Cat 5 cable and shielded RJ45 plugs. Do not connect any other equipment to the phono sockets of the same-numbered Line Input

on the DCM1.

Connect to

Output socket

Screened

Cat 5 cable

LE-1

OUTPUT

LINK

LE-1 (UK version illustrated)

MICROPHONE INPUTS

EXTENSION PORTS

DCM1

Connect to an

unused Extension Port

Note that all LE-1s have two RJ45 connectors, OUTPUT and LINK. These are both mounted on the lower PCB, with the OUTPUT

connector on the right (looking at the module rear), and the LINK connector on the left.

IMPORTANT: Because the cables carry low-level audio, only screened Cat 5 should be used, the foil screen of the cable being

bonded to the metal screening can of the plugs. If an LE-1 is being mounted in close proximity to the DCM1, it may be possible to

use ready-made screened Cat 5 “patch” cables of an appropriate length. Otherwise, shielded RJ45 plugs should be crimped onto

the installed screened Cat 5 cable using the pinout shown below.

1 2 3 4

Sin comentarios

Cloud-electronics LE-1MB Manual de usuario Pagina 3